|
|
|
Kto jest w sklepie?
Sklep przegląda 5959 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
MD-MT180H
Error Messages
ERROR MESSAGES BATT EMPTY BLANK MD MEANING q The battery has run down. q Nothing is recorded. (Replace the disc with a recorded disc.) Can't COPY q You tried to record from a copy prohibited MiniDisc. (Record using the analogue cable.) q You tried to record signals other than music (such as data). Can't EDIT q A track cannot be edited. (Change the stop position of the track and then edit it.) Can't PLAY q You tried to play back a track that cannot be played with this equipment. HOLD LOCKED DISC FULL Er-MD (**) Can'tWRITE DEFECT! ERROR MESSAGES Can'tSTAMP MEANING q Stamp function does not work. (Check the number of tracks.) q Cannot save the TOC information correctly to a MiniDisc. q The disc is scratched. (If the recorded sound is not right, retry recording or replace the disc with a recordable one.) q The disc is out of recording space. q The microprocessor has reported a system fault and the unit is out of order. (To have it repaired, go to the distributor where you purchased the unit.) q The unit is in the hold mode. q You removed a MiniDisc whilst recording or editing. (Turn off the power before removing the MiniDisc.) NO DISC q A disc has not been loaded.
Can't READ (*) q The disc data cannot be read because the disc is damaged. (Reload the Minidisc or replace it with another one.) Can't REC q Recording cannot be performed correctly due to vibration or shock.
Num ber or symb ol appears in (*) posit ion.
ERROR MESSAGES NO SIGNAL
MEANING q Poor connection of the digital cable. q No output signal comes out from the connected unit to playback. (Use the AC power for the connected unit.) q The input signal has improper sampling frequency.
ERROR MESSAGES TEMP OVER
MEANING q The temperature is too high. (Turn off the power, and wait for a while.)
TOC FORM (**)
q There is an error in the recording signal. (Erase all of the tracks, and then record again.)
TOC FULL
PLAY MD PROTECTED
q You tried to record on a playback-only disc. q The write protection tab of a MiniDisc is set to the protected position. q You tried to record on a playback-only disc. Tr. Protect
q There is no space left for recording character information (track names, disc names, etc.). q The track has been protected from being erased. (Edit the track with the device on which it was recorded.)
SORRY
q Since a track number is currently being located or updated, the unit cannot accept your command. (Wait for a while and try the operation again.)
? DISC
q A disc which contains data other than music was played. (A disc which contains nonmusic data cannot be played.) q There is an error in the signal recorded on the disc.
Number or symbol appears in (*) position.
�6�
|
|
|
> |
|
