Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 74 (kliknij aby zobaczyć)
HOW TO SET THE FACTORY PRESETS
Press and hold down CLEAR on the AVC System while it is in standby mode. Then press B (STANDBY/ON) button on the Display or B on the remote control unit to turn the System on. All setting items (except TV channel) return to the factory presetting.
NOTE
� Running the factory presetting operation also clears the password.
You can run the Auto Installation again by using the following steps.
1 2 3 4
Turn on the power of the Display and the AVC System. Press MENU. (Make sure the menu screen displays.) Press c/d to select �Setup�. Press ENTER.
NOTE
� If the password setting screen displays, you need to enter your password. � If you forget your password, refer to HOW TO SET THE FACTORY PRESETS above.
5 6
Press a/b to select �Auto Installation�. Press ENTER.
The password is
NOTE
.
� As a precautionary measure, make a note of your password above, scissor it from this manual, and keep it in a familiar place.
