SHARP CDSW200E
Instrukcja Obsługi

Listening to a CD or MP3/WMA disc

Listening to the radio

FM stereo mode indicator
CD-SW200

CD-SW200

FM stereo receiving indicator

1 2 3

Press the CD button. Press the 1 button and within 5 seconds, press the OPEN/CLOSE button to open the disc tray 1. Place the disc on the disc tray 1, label side up. 12 cm (5�) 8 cm (3�)

1 2

Press the TUNER (BAND) button repeatedly to select the desired frequency band (FM or AM). Press the TUNING ( or ) button to tune in to the desired station. When the TUNING button is pressed for more than 0.5 seconds, scanning will start automatically and the tuner will stop at the first receivable broadcast station.

To receive an FM stereo transmission: Press the TUNER (BAND) button to display the �ST� indicator. � � will appear when an FM broadcast is in stereo.

4 5 6

Press the OPEN/CLOSE button to close the disc tray 1. You can place discs on trays 2 - 5 by following steps 2 - 4. Press the / button to start playback.

Listening to a cassette tape

If trouble occurs
When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is operated incorrectly, it may malfunction. If such a problem occurs, do the following: 1. Set the unit to the stand-by mode and turn the power on again. 2. If the unit is not restored in the previous operation, unplug and plug in the unit, and then turn the power on. Note: If neither operation above restores the unit, clear all the memory by resetting it.

CD-SW200

1

Open the cassette compartment by pushing the area marked � �. 1. 2.

Clearing all the memory (reset)
Press the ON/STAND-BY button to enter the power stand-by mode. Whilst pressing down the button and the X-BASS (SURROUND)/DEMO button, press the TUNING button until "CLEAR ALL" appears.

2

Load a cassette into the TAPE 1 compartment or TAPE 2 compartment with the side to be played facing towards you.
TAPE 1 TAPE 2

3 4

Press the TAPE (1 listen to. Press the /

2) button to select the cassette you want to

Caution: This operation will erase all data stored in memory including clock, timer settings, tuner preset, and CD programme.

(TAPE

) button to start playback.

Maintenance
Routine maintenance is required for continued optimum performance, refer to the operation manual.

CD-SW200E QG

2

10/3/05, 4:03 PM