jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 34 (kliknij aby zobaczyć)
8) Install the eject guide roller belt to the position shown in the figure below.
<2> E clutch unit
1) 2) 3) 4) 5) Remove the cabinet. Remove the main chassis unit. Remove the eject roller unit. Remove the lock of the left bearing. Remove the E clutch unit.
[Note for assembly] Apply grease to the GRE section.
<4> U roller unit
1) 2) 3) 4) Remove the cabinet. Remove the main chassis unit. Remove the locks of the right and left bearings. Remove the U roller unit.
[Note for assembly] Apply grease to the GRE section. 6) Remove the E clutch gear. 7) Remove the bearing. 8) Remove the E clutch roller. 9) Remove the E clutch spring. 10) Remove the E clutch shaft.
[Note for assembly] Clean the CLN section with absolute alcohol.
GRE GRE 5 4 3 2
<5> U left plate unit
1 GRE
1) Remove the cabinet. 2) 3) 4) 5) Remove the main chassis unit. Remove the U roller unit. Remove the feed roller unit. Remove the screw, and remove the U left plate unit.
[Note for assembly] Check that the end of the E clutch spring extends from the concave section of the E clutch roller. Insert the E clutch spring into the square hole of the F arm.
<3> Feed roller unit
1) 2) 3) 4) Remove the cabinet. Remove the main chassis unit. Remove the lock of the left bearing. Remove the feed roller unit.
[Note for assembly] Apply grease to the GRE section.